CSEC Physics · May/June 2019 · Paper 2
32 questions and parts from this paper. Open one to see it in full, then practise it on Quelpr and get it marked against the mark scheme.
- 1(a)3 marksName the parts labelled X, Y and Z.
- 1(b)8 marksUsing the grid on page 7, plot a graph of Vs against Vp.
- 1(c)4 marksDetermine the gradient, S, of the graph.
- 1(d)(i)4 marksUse the gradient, S, to calculate the number of turns in the secondary coil, Ns, given that the number of turns in the primary coil, Np = 85.
- 1(d)(ii)3 marksCalculate the current in the secondary coil, Is, if the current in the primary coil Ip = 1.8 A.
- 1(d)(iii)3 marksCalculate the power output, Pout, of the transformer, given that the voltage in the secondary coil, Vs = 55 V.
- 2(a)5 marksComplete Table 2 by inserting the appropriate physical quantities and derived SI units.
- 2(b)(i)4 marksCalculate the density of the concrete block, given that its mass is 20 160 kg.
- 2(b)(ii)2 marksDefine the term 'pressure'.
- 2(b)(iii)4 marksGiven that g = 10 N kg⁻¹, calculate the pressure exerted on the floor by the base of the concrete block.
- 3(a)(i)2 marksDefine the term 'heat capacity'.
- 3(a)(ii)3 marksDefine the term 'specific latent heat of vaporization'.
- 3(b)2 marksSketch a graph on Figure 4 to represent the statement above.
- 3(c)(i)4 marksCalculate the amount of energy needed to heat the water from 30 °C to 100 °C.
- 3(c)(ii)3 marksCalculate the amount of energy needed to convert the water at 100 °C to steam at 100 °C.
- 3(c)(iii)1 markCalculate the amount of energy needed to heat the water from 30 °C to steam at 100 °C.
- 4(a)(i)3 marksState THREE features of an image produced in a plane mirror.
- 4(a)(ii)3 marksExplain why the word 'POLICE' is painted in this manner at the front of some emergency vehicles.
- 4(b)(i)2 marksComplete the ray diagram to show the path of the emerging ray after it passes through the lens.
- 4(b)(ii)1 markOn the diagram, label the focal length, f.
- 4(c)(i)3 marksCalculate the image distance.
- 4(c)(ii)3 marksCalculate the magnification of the image formed.
- 5(a)2 marksUsing the axes on Figure 6, sketch the I-V graph for the semiconductor diode.
- 5(b)4 marksComplete the truth table shown in Table 3 for a NAND gate.
- 5(c)(i)2 marksCalculate the equivalent resistance of the resistors shown in Figure 7.
- 5(c)(ii)4 marksCalculate the equivalent resistance of the resistors in Figure 8.
- 5(c)(iii)3 marksCalculate the total current flowing through the circuit.
- 6(a)(i)2 marksUse the information given above to determine the number of protons and neutrons present in an atom of lithium-7.
- 6(a)(ii)4 marksDraw a clearly labelled diagram of the structure of the lithium-7 atom.
- 6(b)(i)2 marksDefine the term 'half-life'.
- 6(b)(ii)3 marksCalculate the half-life of lithium.
- 6(c)4 marksCalculate the energy given off in a nuclear reaction if the change in mass is 0.2014 u.