Quelpr
6 marksBearings and Bushings

CAPE Building and Mechanical Engineering Drawing Unit 2 · 2017 · Paper 2 · Question 4(c)

Fully dimension the bushing showing the machining symbols. The internal diameter of the bushing is 30.015 minimum and 30.035 maximum. The outside diameter is 48 (+0.010 / +0.025).

This question uses a figure or table from the paper — you'll see it when you practise.

The mark scheme is shown once you've answered.

Practise this question

Other parts of this question

  1. 4(a)Sketch, freehand and in good proportion, an exploded isometric view of the bearing support including a plain bushing, bolts and gasket.[10 marks]
  2. 4(b)Draw a sectioned orthographic view of the plain bushing.[2 marks]
  3. 4(d)Sketch the symbol that shows a 6 mm fillet weld on both sides.[2 marks]

More practice: the rest of this paper · more Bearings and Bushings questions · all CAPE Building and Mechanical Engineering Drawing Unit 2 past papers