CSEC Technical Drawing · May/June 2013 · Paper 2

16 questions and parts from this paper. Open one to see it in full, then practise it on Quelpr and get it marked against the mark scheme.

1. 1(a)10 marksConstruct the given rhombus ABCD.
2. 1(b)10 marksConstruct a similar figure having twice the area of rhombus ABCD.
3. 2(a)6 marksDraw the given figure.
4. 2(b)14 marksPlot the cycloid generated by point P as the disc makes one complete revolution along surface A-B without slipping.
5. 3(a)8 marksConstruct triangle ABC, given base AB = 70 mm, angle CAB = 45°, and angle ABC = 60°.
6. 3(b)12 marksConstruct an escribed circle to the triangle ABC.
7. 4(a)8 marksConstruct the specified circle and the line BC.
8. 4(b)12 marksConstruct a tangent and a normal to the circle from point C.
9. 5(a)8 marksConstruct the given plan.
10. 5(b)12 marksComplete the elevation showing the line of interpenetration between the cylinder and hexagonal prism.
11. 6(a)6 marksDraw the plan and elevation of lines ab and bc as given.
12. 6(b)6 marksProject an end view to the right of the given elevation.
13. 6(c)8 marksDetermine the true lengths of lines ab and bc using either the revolution or auxiliary method.
14. 7(a)6 marksDraw the orthographic views of the truncated cylinder as given.
15. 7(b)14 marksConstruct the surface development of the truncated cylinder, using the indicated seam position.
16. 820 marksDraw an isometric view of the block with point 'S' positioned at its lowest point. Do not copy the orthographic views.